SF8 Youth / adult prone standing frame
The new SF8 youths / adult prone standing frame has been carefully designed, and constructed from quality materials. It is designed to provide support for prone standing where head control is not a prime concern.
The standing frame is supplied with our unique backsupport system, hip and axilla lateral supports together with lateral leg supports.
Standard Features
- Strong steel frame
- Supplied complete with fully adjustable axilla, hip and leg padded lateral supports
- Large activity tray
- Full back support system (as with all out prone standing frames)
- Large non-marking rubber tyred locking castors
- Wind out and back tilt to approximately 20 degrees
- Maximum weight 95 kg
Options
SF81 Small breast plate for smaller persons (no need for booster base)
Construction
- The frame is constructed from welded square section steel tube for strength
- Timber portions of the frame are finished in a clear, smooth easy wipe clean lacquer.
- Padding is provided where required
Adjustments
Adjustments are simple and easily made. Many can be done witout tools whilst the user is in position. Hand nuts and hand screws are fitted where appropriate.
Breast plate
Breast plate height can be adjusted by means of the 4 hand nuts at the rear of the main board.
- Loosen each hand nut
- Adjust height
- Re-tighten
Do not over tighten as damage to the timbers can occur.
Lateral supports
- Lateral supports can be re-positioned vertically and horizontally
- Philips screwdriver is required
- Loosen screws and position as required
- Tighten screws
Leg / knee assembly
Leg / knee assembly can be positioned vertically as required.
- Loosen hand nuts at rear of main board
- Position as required
- Re-tighten hand nuts
Back support
Back support is held in position by a hook at the base of the support which is fitted into the bar with holes attached to the knee / leg assembly, and by the two strap sets which are attached to the lateral supports.
- Position the hook into the most suitable hole in the bar which will provide firm pressure to the buttocks and clip the straps around the back support
- Try various holes until an even pressure can be applied along the length of the spine
Tilt angle adjustment
- Turn handle anti-clockwise to increase tilt angle
- Turn clockwise to return to vertical
Locking castors
- The rear castors with green lock tabs will lock the castors directionally only, and when on locks the wheels in line with the frame so that they will not interfere with the footplate
- The footplate is designed so that the users feet are as close as practical to the floor
- The front castors with the black lock tabs will lock the castors fully
Activity tray
- Large 575 mm x 580 mm tray with lip around 3 sides is supplied as standard
- Sturdy fitting arrangement allows for use with heavier items such as lap top computer, computer keyboard etc and other activities
- Adjustments include height and angle
To adjust vertical position of tray:
- Hand screws on hinge brackets
- Loosen and slide up or down to required position
- Re-tighten
To adjust angle of tray surface:
- Adjustment tilt by hand screw on telescopic support arm
- Loosen, adjust to suit
- Re-tighten
Meaurements
| Specification | Dimension |
|---|---|
| Height heel to top of breast plate (Standard) | 1170 to 1285 mm |
| Height heel to top of breast plate (Small) | 1100 to 1210 mm |
| Lateral support between | 270 to 370 mm |
| Leg / knee height from heel | 400 to 510 mm |
| Tilt angle | vertical to 20° approx |
| Maximum weight | 95 kilos |